The previous version used another isolation chip that was much more expensive. What’s the difference from the previous, more expensive hi-speed isolator. No driver required, no settings to configure.Works with Thunderbolt ports on the computer, but NOT with (audio) devices that requires Thunderbolt connection.Provides 400mA to the connected USB device (or 500mA if your computer’s USB port can supply Supports audio and other devices including high resolution 384kHz and DSD DACs, USB midi devices, USB mixers, USB microphones.Supports Low (1.5Mbps), Full (12Mbps) and Hi-speed (480Mbps) mode by automatic detection.A handful of audio devices requires Thunderbolt, which is not supported by this isolator.Ī few soundcards like Apollo Twin USB require USB Super speed mode which is also not supported. This isolator does not support USB SuperSpeed 5Gbps, however this mode is rarely if ever used by audio devices. The new isolator also provides more power, 400mA to the connected device, vs 200mA from the other USB isolator. Hi-Speed 480Mbps are required by DACs that support higher than 96kHz/24bit sample rates, and also multi channel DACs. It supports USB transfer modes Low (1.5Mbps), Full (12Mbps) and Hi-speed (480Mbps). The High-Speed isolator provides galvanic isolation between the USB host and device and protects the device from power shocks and avoid ground loops that can be very troublesome in audio.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |